Top

Incorrect status after restart - Zigbee contact sensor

Matter gateway, Matter bridge, Matter over Wi-Fi, and Matter over thread development.


Post Reply
Mathmock
Posts: 9

Hello,

I have a Zigbee contact sensor connected to a Matter bridge.
Whenever the Matter hub is restarted, the contact sensor appears as open, even though there has been no physical action.
In the Tuya app, it appears correctly, but if I access it through Matter, it shows up as open.
This is only resolved when I physically open and close the sensor.

Virtual ID Contact Sensor: ebc2463465d73246caha0q

ID VirtualHub Zigbee Matter: eba6ffcbd9c94db8be2dxl

zhicheng
Posts: 2

Re: Incorrect status after restart - Zigbee contact sensor

Hello, could you please confirm whether this issue (where the contact sensor is physically closed but shows as open on third-party platforms) only occurs when the Matter hub restarts? Or does the status of this contact sensor displayed on third-party platforms such as Apple Home always contradict its actual physical state?

Post Reply