Page 1 of 1
Tapo T110 Smart Contact Sensor
Posted: 2025年 Nov 23日 23:50
by Sugar
Wrong status, it's On when it should be Closed, and it is Off when it should be Open.
In the historical record, the same issue, On when it should be closed and Off when it should be open.
The name of the device should be Tapo T110 Contact Sensor.
Virtual ID of Tapo T110 sensor is: bf71692d0babf464fdh5zm
Virtual ID of Moes Hub is: bfdd385cadc34fdb76jlx7
Additionally, it is, it's not possible to change child device names at all or add child devices to the main screen, or any room.
Thank you if possible to fix it 
Re: Tapo T110 Smart Contact Sensor
Posted: 2025年 Nov 25日 14:05
by fangping.guo
This question has already been replied to in another post.
Re: Tapo T110 Smart Contact Sensor
Posted: 2025年 Dec 1日 06:26
by Sugar
fangping.guo 2025年 Nov 25日 14:05
This question has already been replied to in another post.
Hi if you could reverse status like with that motion sensor.
So at least off will be door closed and on doors opened.
Thank you.
Re: Tapo T110 Smart Contact Sensor
Posted: 2025年 Dec 2日 14:06
by fangping.guo
As you requested, I have reversed the current state configuration. You can restart the gateway and wait a few minutes to verify if this resolves your issue.