Tuya Developer Forum

Today I will test the two dimmers that you adjusted.

JorgeFrancisco 2025年 May 28日 20:58

I changed the hub and the sensors continued with the value of 20%, today they appeared with the value of 100%.

Allright, I will try to reduce the battery value by five times.

After receiving the message, please remove the device from the gateway and then configure the rear bridge to matter.

Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.

JorgeFrancisco 2025年 May 29日 16:57

Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.

I don't quite understand your meaning. When I replied last time, I had already completed the modification.

I suggest that you can retest it and then tell me the latest data situation so that I can make corresponding adjustments.

Unfortunately, the sensors continue to have the wrong value of 20%, and should have the value of 100%. Could you go back to the adjustment by multiplying the value by 5 again?

qiusui 2025年 May 29日 17:21

JorgeFrancisco 2025年 May 29日 16:57

Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.

I don't quite understand your meaning. When I replied last time, I had already completed the modification.

I suggest that you can retest it and then tell me the latest data situation so that I can make corresponding adjustments.

Could you check? Please. Return the change and multiply by 5?

JorgeFrancisco 2025年 Jun 4日 08:12

qiusui 2025年 May 29日 17:21

JorgeFrancisco 2025年 May 29日 16:57

Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.

I don't quite understand your meaning. When I replied last time, I had already completed the modification.

I suggest that you can retest it and then tell me the latest data situation so that I can make corresponding adjustments.

Could you check? Please. Return the change and multiply by 5?

Fine, I will return the change.

Please also check the zigbee fan coil thermostat below to make sure all its values are displayed properly under Home Assistant.

Thermostat (unsupported) (mpbki2zm)
by Tuya

https://vi.aliexpress.com/item/10050056 ... pt=glo2vnm

I have updated the device files, please try updating the gateway version and test by unbinding the device and then rebinding it. Looking forward to your feedback.

Thank you!

Almost fine, but the fan speed is not selectable.