Devices are not exported to Home Assistant as Matter

[JorgeFrancisco]

Today I will test the two dimmers that you adjusted.

[qiusui]

I changed the hub and the sensors continued with the value of 20%, today they appeared with the value of 100%.

Allright, I will try to reduce the battery value by five times.

After receiving the message, please remove the device from the gateway and then configure the rear bridge to matter.

[JorgeFrancisco]

Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.

[qiusui]

Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.

I don't quite understand your meaning. When I replied last time, I had already completed the modification.

I suggest that you can retest it and then tell me the latest data situation so that I can make corresponding adjustments.

[JorgeFrancisco]

Unfortunately, the sensors continue to have the wrong value of 20%, and should have the value of 100%. Could you go back to the adjustment by multiplying the value by 5 again?

[JorgeFrancisco]

Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.

I don't quite understand your meaning. When I replied last time, I had already completed the modification.

I suggest that you can retest it and then tell me the latest data situation so that I can make corresponding adjustments.

Could you check? Please. Return the change and multiply by 5?

[qiusui]

Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.

I don't quite understand your meaning. When I replied last time, I had already completed the modification.

I suggest that you can retest it and then tell me the latest data situation so that I can make corresponding adjustments.

Could you check? Please. Return the change and multiply by 5?

Fine, I will return the change.

[Yocee84]

Please also check the zigbee fan coil thermostat below to make sure all its values are displayed properly under Home Assistant.

Thermostat (unsupported) (mpbki2zm)
by Tuya

https://vi.aliexpress.com/item/10050056 ... pt=glo2vnm

[fangping.guo]

I have updated the device files, please try updating the gateway version and test by unbinding the device and then rebinding it. Looking forward to your feedback.