Today I will test the two dimmers that you adjusted.
Devices are not exported to Home Assistant as Matter
Re: Devices are not exported to Home Assistant as Matter
JorgeFrancisco 2025年 May 28日 20:58I changed the hub and the sensors continued with the value of 20%, today they appeared with the value of 100%.
Allright, I will try to reduce the battery value by five times.
After receiving the message, please remove the device from the gateway and then configure the rear bridge to matter.
-
- Posts: 14
Re: Devices are not exported to Home Assistant as Matter
Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.
Re: Devices are not exported to Home Assistant as Matter
JorgeFrancisco 2025年 May 29日 16:57Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.
I don't quite understand your meaning. When I replied last time, I had already completed the modification.
I suggest that you can retest it and then tell me the latest data situation so that I can make corresponding adjustments.
-
- Posts: 14
Re: Devices are not exported to Home Assistant as Matter
Unfortunately, the sensors continue to have the wrong value of 20%, and should have the value of 100%. Could you go back to the adjustment by multiplying the value by 5 again?
-
- Posts: 14
Re: Devices are not exported to Home Assistant as Matter
qiusui 2025年 May 29日 17:21JorgeFrancisco 2025年 May 29日 16:57Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.
I don't quite understand your meaning. When I replied last time, I had already completed the modification.
I suggest that you can retest it and then tell me the latest data situation so that I can make corresponding adjustments.
Could you check? Please. Return the change and multiply by 5?
Re: Devices are not exported to Home Assistant as Matter
JorgeFrancisco 2025年 Jun 4日 08:12qiusui 2025年 May 29日 17:21JorgeFrancisco 2025年 May 29日 16:57Hi! You don't need to change anything else, it is already displaying the correct value, which is 100%. You can leave it multiplying by 5.
I don't quite understand your meaning. When I replied last time, I had already completed the modification.
I suggest that you can retest it and then tell me the latest data situation so that I can make corresponding adjustments.
Could you check? Please. Return the change and multiply by 5?
Fine, I will return the change.